Suite Protection Calculation Factor

Questions about using and the information behind / in any of the reports and schedules generated by DraftLogic Electrical.

Suite Protection Calculation Factor

Postby forumadmin » Sat Sep 28, 2013 10:55 pm

In the 4.1 release of DraftLogic Electrical, shipped October 2013, the protection calculation factor has been split apart for suite panels and all other panels. Now when you run any report that uses the Load Calculator, if you have any suites they will use the new 'Suite Protection calc Factor (%; No min)' project parameter for their feeder and protection calculations. The default value on this new parameter is 0% versus 25% for the 'Protection calc Factor (%; CEC Min 25)' project parameter.

Here is the new Panels parameter category, the new 'Suite Protection calc Factor (%; No min)' project parameter is the second last one on the list.

Panels Project Parameters
Panels_Parameters_20130928.PNG (16.93 KiB) Viewed 18151 times
Site Admin
Posts: 87
Joined: Fri Sep 11, 2009 5:46 am

Return to Reports and Schedules

Who is online

Users browsing this forum: No registered users and 1 guest