Page 1 of 1

Suite Protection Calculation Factor

PostPosted: Sat Sep 28, 2013 10:55 pm
by forumadmin
In the 4.1 release of DraftLogic Electrical, shipped October 2013, the protection calculation factor has been split apart for suite panels and all other panels. Now when you run any report that uses the Load Calculator, if you have any suites they will use the new 'Suite Protection calc Factor (%; No min)' project parameter for their feeder and protection calculations. The default value on this new parameter is 0% versus 25% for the 'Protection calc Factor (%; CEC Min 25)' project parameter.

Here is the new Panels parameter category, the new 'Suite Protection calc Factor (%; No min)' project parameter is the second last one on the list.

Panels_Parameters_20130928.PNG
Panels Project Parameters
Panels_Parameters_20130928.PNG (16.93 KiB) Viewed 17631 times